DRIVERS FOR NEMATRON PLC WORKSTATIONS

ND 010 05 KM PS306/316 Nematron Driver

The protocol driver for the Series 30, 110 and 120 PLC Workstations to connect with a Klockner Moeller SUCOS PS306 or PS316 Programmable Controller. The Driver uses serial communication with the controller through the RS485 port.

There are two different addressing schemes available for accessing of PLC memory areas: by symbolic or absolute address. The following PLC memory areas are supported: Flags (Markers), Binary Inputs and Outputs, Analog Inputs and Outputs, Parallel bus peripherals, Absolute Address Bits and Words.  

ND 010 10 KM PS - 4 Nematron Driver

The protocol driver for the Series 30, 110 and 120 PLC Workstations to connect with a Klockner Moeller PS 4 - 201 PLC. The driver uses serial communication with the controller through the RS 232 port.

Due to the dynamic memory management in the Klockner Moeller SUCOcontrol PS4 PLCs, the KM PS-4 Nematron Driver supports access only to markers of the basic unit. Other operand types (inputs, outputs, parallel bus markers, etc.) can be accessed through the basic unit markers by adding appropriate instructions in the PLC program. The start and end addresses of active marker area are determined at Driver startup.

ND 020 05 ABB CS31 Nematron Driver

The protocol driver for the Series 30, 110 and 120 PLC Workstations to connect with an ABB CS 31 Procontic PLC. The driver uses serial communication with the controller through the RS 232 port.

The following PLC memory areas are supported: Binary Inputs and Outputs, Binary Flags, Binary Steps, Binary Indirect Constants, Word Inputs and Outputs, Word Flags, Word Indirect Constants, Double Word Flags, Double Word Indirect Constants.